Call now to get tree helping such as tree clearing, tree felling, bush delimbing, shrub cleanup, stump chop and bunch of others in USA.

Click to call

Call us now +1 (855) 280-15-30

The primary shaft is out on my bench but I can see.

Aug 27, the new one piece push rod is now a superb fit in the bush and hopefully should not enlarge the oil seal and leak oil again.! Between the worm gear and clutch is a series of rods and balls. If you want to replace the two piece rod and ball with a one piece rod then pulling the seal and bushing eases the removal of the ball and inner rod.

Feb 20, Here's a clear pic of the XS clutch pushrod. The main body is aluminum (unknown alloy), with a short steel tip at the clutchpack end, and a longer steel shaft to pass through the pushrod seal and bear against the clutch actuator worm.

Considering whether it's feasable to conduct this experiment.

According to postings on our sister xs forum, these parts appear to be press-fitted together. Clutch Pushrod (Long one-piece rod). Replaces both inner and outer pushrod and outer ball bearing used on 's. Provides more stable action and allows less wear of clutch pushrod seal. Fits: 's. Stock original type for models. (Note photo not.

Jun 07, The pushrod bushing is just a standard metric sleeve bearing or bushing, cheaper from some industrial supply place like McMaster-Carr than from Mike's. The best quality single long pushrod is a Yamaha one.

Not available from Yamaha anymore but they pop up on eBay all the time. Description. Clutch pushrod shaft Bushing - Replaces original bushing inside of pushrod housing (tranmission shaft) and brings clearances back to original.

When stock clearances are too large the pushrod moves to the side and increases tearing stress on the pushrod seal. (See our catalog for detailed installation proceedure). Clutch Pushrod (Short outer rod). - Stock part for 's.

The oil does get pumped into the area behind the seal.

Motorcycle Fitment & OEM Information. Is Universal Part: No. OEM Number (s): N/A. Motorcycle Fitment: Yamaha XS XSC. Yamaha XS XSD. CLUTCH PUSHROD SEAL Clutch Pushrod Seal - Made in Japan by original maker G- Push the new rolled bushing in the end of the shaft and carefully tap it into place until it is flush with the end of the shaft.

H - Install a New clutch pushrod oil seal, the long clutch pushrod and the ball bearing and the short clutch push-F. The 23/64" bit will.