Project Location: Toney, AL Date: 03/ Comment: This is a land clearing for new construction that requires the complete removal of stumps from the build sight. new consruction. Drill Holes in the Stump. Cut off as much of the top of the stump as possible with your chainsaw. Use a 1-inch spade bit with a spade bit extension to drill evenly spaced holes roughly every 6 to 8 inches around the perimeter of the stump. Make the holes about 12 inches deep and three to Estimated Reading Time: 3 mins.
Mar 09, Here is a quick guide for DIY stump removal. Removing a Tree Stump by Burning. For this method, drill a hole in the center of the stump about inches deep and clean out the debris out of it.
Drill more holes on the stump surface 1 inch apart, and fill each hole with potassium stumphauling.buzzted Reading Time: 4 mins. Drive the teeth close to the stump and turn on the machine.
Raise the cutting wheel of the grinder a few inches above the front edge of the stump with the brake lever. Turn on the spinning cutting wheel and slowly lower it onto the stump. Allow it to gnaw at the surface with sideways movement.
Aug 31, Use a chain saw or bow saw to cut the stump down as close to the ground as you can, without allowing the chain saw's teeth to strike the ground (this will dull your chain). Wear steel-toed boots for this part of the job. Drill holes a few inches deep into the stump in numerous places, using the biggest, widest drill bit you have.